- Attaches to rear racks - Compatible with: Blinky 3,5,7 and Superflash - 25mm between each of the top horizontal holes (center to center) - Requires an "L bracket" that typically comes with a rear rack. If your rack is missing the L bracket, you can purchase Planet Bike's rack hardware pack
Emax+ 150 is NiteRider's first taillight specifically made for electric bikes. It comes with a power line that's pre-wired for connection to the eBike's battery. Power line cable measures approximately 52" in length. Taillight powers ON with ignition/ power switch. Features six modes-Steady ON and varying flashes-with Built-in Mode Memory (remembers last setting). FEATURES - Lumen Output: 150 - 6 Modes - Hardwired, Voltage 6 to 80 Volts DC - Water / Dust Resistant IP64 Rated - Weight: 75 grams - Fits 22mm-34.9mm seat posts - Includes a pre-wired Emax+ 150 Taillight, Seat Post Clamp Mount, Rubber Mounting Shims, and Rack Mount LIGHT MODES 1) Fast Flash 2) Slow Flash 3) Disco Flash 4) Pulse Flash 5) High Steady 6) Low Steady NiteRider recommends this taillight be installed by an authorized e-bike service and repair shop.
High-performance e-bike cycling light. Durable, heat-dissipating CNC machined aluminum construction. Two ultrahigh-output LEDs deliver up to 1,000 lumens. Enhanced MOR (Maximum Optical Reflection) lens with built-in side visibility. Intelligent Auto Day/Night dim mode. E-bike compatible 6 - 12v input, 6w easily plugs into batteries from top makers including Bosch, Shimano and Yamaha. Includes a Direct X-Lock and aluminum CNC fork mount and 140cm long power cable. Our e-bike lights are powered by the motor of an e-bike and need to be manually installed. Proper installation may require some disassembly of the bike and motor (depending on make and model battery type) and additional wiring to connect the light to the motor. Please contact the e-bike or motor manufacturer for installation instructions. It is highly recommended to have a trained e-bike professional install your lights for you. *Direct X-Lock Mounting System not compatible with all stems. Please see installation manual for stem compatibility. Specs - Max Lumens: 1000 - Dimensions: 44.5 x 41 x 31mm / 1.75 x 1.61 x 1.22"
Bright and efficient multi-purpose e-bike cycling light. Durable, heat-dissipating CNC machined aluminum construction. Two ultra-high-output LEDs deliver up to 500 lumens. Enhanced MOR (Maximum Optical Reflection) lens with built-in side visibility. Intelligent Auto Day/Night dim mode. E-bike compatible 6 – 12v input, 6w easily plugs into batteries from top makers including Bosch, Shimano and Yamaha. Includes CNC fork mount and 140cm long power cable. Our e-bike lights are powered by the motor of an e-bike and need to be manually installed. Proper installation may require some disassembly of the bike and motor (depending on make and model battery type) and additional wiring to connect the light to the motor. Please contact the e-bike or motor manufacturer for installation instructions. It is highly recommended to have a trained e-bike professional install your lights for you. *Direct X-Lock Mounting System not compatible with all stems. Please see installation manual for stem compatibility. Specs - Max Lumens: 500 - Dimensions: 44.5 x 41 x 25mm / 1.75 x 1.61 x 0.98"
German StVZO optimized lens with wide light spread. Two high-output LEDs provide 12 lumens. IPX7 water resistant rating. Composite matrix construction. E-bike compatible (6v input, 0.4w / 12v input 0.8w) easily plugs into batteries from top makers including Bosch, Shimano and Yamaha. Stainless Allen key hardware and 130cm-long power cable included. 50 and 80mm mount spacing. Our e-bike lights are powered by the motor of an e-bike and need to be manually installed. Proper installation may require some disassembly of the bike and motor (depending on make and model battery type) and additional wiring to connect the light to the motor. Please contact the e-bike or motor manufacturer for installation instructions. It is highly recommended to have a trained e-bike professional install your lights for you. - Two high-output LEDs provide 11 lumens - StVZO optimized lens with wide light spread - E-bike compatible 6 – 12V input, 1.25W - Composite matrix fender-mounting system - IPX7 water resistant - Stainless Allen key hardware included - 130 cm power cable included
Different light technologies for different urban riders. The MOB's have a range of weapons to beat the competition. Like 3 (rear) interchangeable straps – including one to fit aero posts. Their beams range from ultra-focused to ultra-wide so they never get caught out. And you ain’t never seen flash patterns like these before. Features -LEDs : Surface Mount (SMT) LED designed to provide maximum brightness level for up to 90% of the battery burn time for each mode. -BEAM ANGLE : 120° -BAR DIAMETERS : Fits seatposts 22-32mm+ and aero posts. -INTEGRATED USB PLUG : Designed to be exposed to the elements, is waterproof and will not be damaged by exposure. -BUTTON : Longer button push on (0.75sec) prevents accidental turn on. Short presses switch modes continuously. -STORAGE MODE : Light can be placed in storage mode if not used for a long time (see instructions for full details). -STRAPS : Replaceable straps for tool-less attachment 100% WATERPROOF: The Blinder MOB is IP67 Tested and 100% waterproof against all elements
The Blinder Road 400 features all the best attributes of our original Blinder Road, but now with a powerful 400 lumens of light output. When this increase of illumination power is combined with the carefully considered beam angles for road riding, you have Knog's most powerfully perfect road bike light ever. Advanced LED's & Optics There is no such thing as a universal bike light. End-use and even bike type can dictate the best bike light to use. Blinder Road's two LEDs are each independently capable of 250lm of output or 400lm when used together. The LHS optic has a 12-degree beam providing a spotlight that is perfect for racing and fast riding on smooth roads, while the RHS Optic has a 32-degree beam proving a floodlight which is best suited for use on slower rides on bumpy or uneven riding conditions. Each LED has a variety of flash patterns and functions independent of the other. Unique Fastening System Utilizing silicone to create the elastomeric strap combined with an over-molded polycarbonate clip system allows Blinder Road to adapt to the many various configurations required of today's road cyclists, many of whom have GPS systems on their bikes. The Blinder Road is stylish and versatile enough to fit with a multitude of today's high-end bicycle cockpits (includes two removable silicone straps for bars 22-28mm & 29-35mm). Waterproof & Integrated USB Charging The Blinder road is 100% waterproof with a rating of IP67, which means you submerge your light in depths greater than 1 meter for over 30 minutes without damage (note if you are under 1 meter of water on your bike, the waterproofing of your light is probably the least of your worries). The light is charged via integrated USB, which means it does not require additional cables to charge from a USB Port, and there's no need for single-use batteries. Intuitive Functionality When your Blinder is running low on battery, a red led will light up next to the button. This ring will turn green and then turn off once the Blinder is fully charged and ready to go. With a design that is wider rather than longer, accommodating the 2 optics side by side keeps the center of gravity as close to the handlebar as possible which avoids the potential for movement on bumpy roads. Finally, the Blinder Road's buttons and strap closures are all at the perfect ergonomic angle and are long enough to be used while wearing gloves. - Dimensions: H: 63mm x W: 30mm x L: 53mm - Weight: 70g - Lumens: 400
'Aero is everything,' and this is especially true with our Blinder V Traffic rear light. Using new COB technology, the Blinder V Traffic produces a punchy 100 lumen output, that will ensure you're seen and safe in all lighting conditions. It features a unique 3 block, traffic light style face pattern (all red) that makes the Blinder V Traffic one of Knog's most individual lights ever and the graphic flash pattern has 8 different light modes. The Blinder V Traffic is USB rechargeable, has an integrated USB-A connector, is 100% waterproof (IP67 rating) and has a whopping 50 hour run-time when using eco flash mode. - Dimensions: H: 51mm x W: 44mm x L:77mm - Weight: 40 grams - Lumens: 100 USB RECHARGEABLE WITH INTEGRATED CONNECTOR No charging cable is required for your Blinder V Traffic, its integrated USB plugs directly into USB ports. A full charge is achieved in 4 hours. When your Blinder is running low on battery, a red ring will light up around the button. This ring will turn green and then turn off once the Blinder is fully charged and ready to go. SIMPLE & SMART FASTENING SYSTEM The Blinder V Traffic comes with three silicone straps. A small strap for seat posts 22 – 27mm diameter, a medium strap for seat posts 27-32mm in diameter and a large strap that will fit tubes profiles with a circumference of up to 200mm. Our tool-less mounting system makes attaching your light incredibly simple and silicone straps means there'll be no chance of damaging your bikes frame. EASY ON, EASY OFF Removing your Blinder V Traffic for charging or security purposes is a doddle with our handy clasp removal system. Strong enough to hold your light firmly in place when in use and big enough to use even when wearing gloves in colder conditions, this is a king amongst clasps.
Lil' Cobber Rear produces an incredible 330º of light, so you'll be clearly seen from all angles. In an increasingly busy world, this bike light is brilliantly effective at attracting attention and helping keep you safe on the road. Packing 50 lumens this Lil' Cobber is seriously bright. The Cobber has integrated USB recharging, is 100% waterproof and you can program the settings using the Modemaker app. It mounts with tool-less removable silicone straps for bars/seat posts 22 – 32mm+ diameter with magnetic mount (aero Mount also included). If you are looking for the best rear commuter bike light around, look no further. - Light modes: Max, Mid, Steady Pulse, Flash, Eco Flash come pre-programmed - LEDs: Efficient Chip on Board (COB) LEDs designed to provide maximum brightness level for up to 90% of the battery burn time for each mode - Integrated USB plug: No charging cable required, plugs directly into USB ports & is designed to be exposed to the elements - Charge time: 4 hours (LED will turn off when fully charged) - Battery: USB Rechargeable Lithium Polymer - Accessories included: Standard Mount, Aero Mount, 3x interchangeable straps for bars/seat posts 22-27mm / 28-32mm+, and USB extension.
An attachment to use when mounting your PWR Rider or PWR Commuter bike lights to your helmet. PWR Red Cap gives you a 12 lumen narrow rear light beam for day & night visibility. Use the Modemaker app to program your rear light. - Includes: - PWR Red Cap Rear Light - Helmet Mount (also works with GoPro mount) - Adaptor - Hex Keys
$89.95 $99.95 10% Off
PWR Road is a modular bike light—but it's not JUST another bike light. Not only is it a high-powered bike light, but simply take the product apart and you have much more. It's a lighthead and a PWR Bank to charge devices that is also the battery for all products in the PWR range. Battery Indicator Hate it when you run out of battery with no warning? That'll never happen with PWR Road, with 4 built-in battery indicator lights. Tap the bottom of the light to activate the battery indicator. 4 lights = fully charged, 2 lights = half charge, etc. Easy to Mount and Use This light can be mounted on top or below your handlebars, directly under your Garmin, or on your helmet. It comes with a side mount and shim that fits handlebars 22.2 – 38.1mm diameter. Once mounted, using PWR Road is a breeze. It's a simple twist-head operation to turn light on & off and to scroll through light modes Charge Your Devices Press the red button to release the light head, and use the PWR bank to charge your phone, GoPro, cycle computer, or other devices. Charge your PWR Road using the included micro USB cable. Wide Beam and Customisable Modes PWR Road outputs a max of 700 lumens and can run for up to 195 hours on Eco Flash Mode. Its elliptical beam gives broad, bright road coverage. It comes with 6 pre-program d modes, and you can program the light to suit your needs with Modemaker. You can control brightness, adjust runtimes and add new light modes. - Dimensions: H: 128mm x W: 31mm x L: 31mm - Weight: 125g - Lumens: 700
The Plus rear bike light is a super-bright, 100% waterproof and versatile USB rechargeable bicycle light. Mount the light to your seatpost, seat stays, and pannier racks, or use the integrated wearable clip to attach the light to your t-shirt or backpack. More of a runner than a cyclist? No worries. The Plus light also doubles up as a wearable night running light. Just attach the light to your t-shirt, shorts, socks, or headband using the smart integrated clip. With an output of 20 lumens and a run time of up to 40 hours in eco flash, the Plus ensures you are well seen to all other cyclists, road users, and trail runners all night long.
Page 1 of 1